This is a programmed Guided Ordering Channel where options and choices are presented to you according to the 'bridge saddle spread' that you indicate below and the 'type of cover' you indicate on the SPECIFY Tab. Get those right and you can't go wrong. However we check all orders and we will check with you if we spot a mistake.
Please type complete and accurate the model ID specified by manufacturer. No Serial numbers please. Examples: 1998 American Standard / 2011 Strat Deluxe / Les Paul copy / etc.
Saddle Spread (Very Important):
It is very important you indicate the correct bridge because the website will allocate the pole spread for this pickup according to the bridge saddle spread you click. This will assure satisfactory alignment of the poles and strings, resulting in good string loudness balance.
Strat VINTAGE 6 point
Most other bridge
Right Handed
0.00 USD
Left Handed
0.00 USD
Type of Cover:
Soapbar
Dog-Ear
Pole Spread will be which suits the bridge Saddle Spread you selected.
NOTE: If you want to use your original Dog-Ear cover and it’s got a different pole spread (50mm) from that indicated above (47.5mm) just tell us in the ADDITIONAL NOTES Box on the shipping page -or- send a Contact message after you submit your order.
Metal Dog-Ear covers are not available for 53mm pickup pole spread however plastic covers without holes that can be drilled to suit any pickup are available on eBay,,, Search "Dog-Ear covers no holes".
Modern soapbar Gibson's have a magnetic mounting plate on the floor of the pickup cavities. This must be replaced with our non-magnetic plate in order not to comprise beyond excellent hum cancelling of our P-90 Hx. This kit included everything you need and is easily swapped. Should your Gibson not have a mounting plate then do not include this kit, so if you are not certain please take a peek under a pickup.
Remove one mounting screw (not both) and look at the thread form. If it is a fine thread form like shown for the two long screws top left of the picture of the mounting plate kit then it's a sure thing you have the steel mounting plate. However, if the thread form is coarse, more like the two shorter screws on the right side of the picture then we would think you do not have a metal mounting plate. To be absolutely certain you should loosen the strings, remove both mounting screws and take the pickup out of it's cavity and check the floor of the cavity (no need to disconnect any wiring to do this).
New build guitars will also benefit with this plate since it provides an easy and accurate way to position mounting screws for Soapbar pickups, and provide smooth and easy height adjustment.
Are these pickups are for a Gibson ES175, Epiphone Casino or other hollow body f-hole guitar with Dog-Ear covers? These will need a Kinman Dog-Ear cover Mounting Bracket for each pickup
NOTE 1: Some Epiphones such as the Casino "Coupe" have a routed neck pickup cavity which does not require a bracket but the bridge still does, check the cavities before proceeding. Take the pickups out of other brand guitars to see if a bracket is required for each pickup too.
NOTE 2: For other brands of f-hole guitars check the 'Install requirements' file to see if the Mounting Bracket will fit.
Kinman P-90 Hx Dog-Ear mounting bracket
Cream
Black
Nickel-Silver
Cream
Black
Logo Option
Cream
Black
Nickel-Silver
Logo Option
White
Parchment
Black
Logo Option
Get the most out of your new pickups by providing them with optimum electrical environment so they achieve their full sonic potential with our Goodbye-Soldering Harness (DIY Plug-n-Play install kit) where pickups & higher quality controls & wiring are installed fast and easy without any soldering.
Please go to the TAB below and choose your Harness model.
Choose Plug into a Kinman Harness if the pickups are to be used with an existing Kinman Goodbye Soldering Harness Note: Older versions of Kinman Harness use solder connections, please check
Cables are long enough for Stock guitars. If you require longer cables send a follow-up 'CONTACT' message stating the length of cables you require.
Cable length of our Humbucker and P-90 Pickups is: 380mm or 15 inches
Choose Plug into a Kinman Harness if the pickups are to be used with an existing Kinman Goodbye Soldering Harness
Note: Older versions of Kinman Harness use solder connections, please check
Cables are long enough for Stock guitars. If you require longer cables send a follow-up 'CONTACT' message stating the length of cables you require.
Not all Gibson's have this connector, you need to check inside your guitar. see the image below
Molex 2 wire plug
Molex 5 wire plug
Please indicate what the Bridge pickup is: Humbucker* or P-90 it will have 500k Volume pot load Strat pickups will have 250k Ohm Volume pot load.
NOTE: * Humbuckers can not be split to single coil with this harness.
Choose the K9-H instead.
Please indicate what the Bridge pickup are: Humbucker* or P-90 it will have 500k Volume pot load Strat pickups will have 250k Ohm Volume pot load.
NOTE: * Humbuckers can not be split to single coil with this harness.
Choose the K9-H instead.
Strat pickups require 250k volume pot load.
Which positions are for Humbucker or P-90 that require 500k volume pot load.
Is the harness for a rear rout install where the controls are mounted through the wood? Click to see image.
Choose For Soldering into your guitar if the pickups are to be connected to stock guitar electrics other than a Kinman Goodbye Soldering Harness that uses miniature plugs.
3 conductor hook-up cable is necessary for Series switching and/or Phase reversing.
This kit is positive latching and will not come apart without force. It has short leads and is intended to connect a normal pickup hook-up cable to the original pickup cable after the original pickup has been cut from it. Details are in >Technical >Install Guides.
Choose For Soldering into your guitar if the pickups are to be connected to stock guitar electrics other than a Kinman Goodbye Soldering Harness that uses miniature plugs.
if in doubt choose the first option since it suits either shielding condition
3 conductor hook-up cable plus grounded magnets are necessary for Series switching and/or Phase reversing. (in a set of 3 in a Kinman K9 harness, it's for middle pickup only) +$15 upcharge.
Cables are long enough for Stock Strats. If you require longer cables state the lengths you require in the ADDITIONAL NOTES box on the Shipping page. Lengths stated below are from the middle of the pickup to the tip of the cable.
Dog Ear covers are not available in the required 53mm Pole Spread since you indicated the bridge saddle spread is greater than 53.5mm.
To include a KHP-90 harness after this order is added to the CART please swap to a PC and log-in and navigate to the Harness section and click Gibson type harness and ADD TO CART. Or send a separate order from the PC site.
You indicated bridge saddle spread of greater than 53mm which requires pickup pole spread of 53mm for optimum string-over-magnet alignment. However Dog-Ear covers are not available in 53mm so here are your options ..
1. Check your bridge saddle spread and change your selection on the first tab if wrongly entered.
2. Try to buy Dog-Ear covers without holes and drill them to 53mm. Search Ebay and other vendors for undrilled covers.
3. Dog-Ear covers can not be included as the order stands however you can still proceed with the order.
Synergy is an interaction or cooperation giving rise to a whole that is greater than the simple sum of its parts. The term synergy comes from the Attic Greek word συνεργία synergia meaning working together.
An opus is a created work, usually musical in nature.
A common usage of opus is with the term magnum opus which refers to one's greatest work, musical or otherwise
https://www.vocabulary.com/dictionary/opus
this_content
