Technical & Application info:

 All models have absolute Zero-Hum.  Enhanced Split Single Coil (ESSC) is not hum cancelling.

WR Humbucker (with optional ESSC) and a single or double row of pole screws.
    Heavy:  Clear and well defined dirty growl for the bridge position (no mud).   Rock, Reggae, Pop, Jazz, Country, Indie,
    Lite:  Bright, sweet and beautiful tone and it’s very dynamic with a very bouncy low wound string sound.  Well behaved in the neck position
              and absolutely no slop or messy bass side sounds.  Rock, Reggae, Pop, Jazz, Country, Indie, Instrumental.
    Custom:  Any conventional humbucker sound you can think

WR P90-Bucker
    three sounds available, dirty growl Heavy Bridge, Clean Bridge and Sweet Neck.  All produce a very clear and highly dynamic sound with
    uncommon touch sensitivity.

WR Twang-Bucker
    Twango Intenso, strong sharp twang with heaps of presence and dynamics from both neck and "Whopper" bridge models.

WR Jazza
    Uniquely beautiful, sweet sound without too many piano mid-tones from the Low wound strings

Our pickups are over engineered and designed carefully so that wax potting has no detrimental effect on sound.  All Kinman's are wax potted and you have the freedom to utterly saturated their sound in distortion without a hint of microphonic feedback or howl.

Our covers are made of Nickel-Silver and we make our own non-magnetic baseplates so there is no degradation of tonal nuances.

Dimensions & Pickguard opening template & cavity routing template.
•    Dimensions  (same as standard Wide Range humbucker)
•    Routing Templates

Mounting hardware (included)
•    4 pieces (3-48 UNC) mounting screws, Phillips drive (3 is preferable but you can use 2 of 4 if you prefer)
•    Silicon rubber tube springs

Hook-up wires (allows phase reversing)
•     Robust single wires for soldering, requires effective shielding in wiring tunnels to prevent electrical buzz
•     3conductor shielded cable with or without Kinman Harness Plug.  Wiring tunnel shielding not required

Connection means
•     For soldering
•     Plug for Kinman Goodbye-Soldering Harness

Cover options
•     Hand buffed Nickel-Silver.  Best sonic performance and immunity to feedback screech.  Suitable for relic-ing and deliberate aging
•     Will lose it's mirror-like polish naturally in a few months unless you maintain it with occasional application of clear liquid guitar polish
•     With or without Kinman logo

Pot & Capacitor values
•     Best with 250k Ohm volume pot.  500k for thinner sound and a little less spank/punch.
•     Tone pot is usually the same value as the volume but for a little more top end brightness can be 1meg or No-Load.
•     Stock pots can actually measure as low as 130k.  Pots in our Goodbye-Soldering Harness are guaranteed to measure no less that 250k.
•     Normal tone cap value of 0.022uF, 63 ~ 100 volt Polyester.  Smaller uF value lessen the severity of Treble cut, higher values increase it.
•     The voltage rating of Caps is not important but 63 ~ 100 volt have thicker lead wires that are easy to work with and just look better.

Output Polarity
•     Phase reversible so it's compatible with any other pickup regardless of brand or type 

highly recommend consulting the Install Guide in the Technical section even if you think you know it all.  There is also a handy wiring diagram available.

We also highly recommend consulting the Adjust & Set-up page in the Technical section so you get the best out of your Kinman pickups.