Please type complete and accurate the model ID specified by manufacturer. No Serial numbers please. Examples: 1998 American Standard / 2011 Strat Deluxe / Les Paul copy / etc.
Right Handed
0.00 USD
Left Handed
0.00 USD
Gold Plated Magnets & Mounting Screws
Gold Plated
Non-Plated
Pease Select Plated Magnets & Mounting Screws First
White
Aged White
Black
Parchment
White
Aged White
Black
Parchment
Note: These Colors do not accurately represent the actual covers, however are close enough to make a decision on.
Normal Baseplate
+0.00 USD
Parallel Baseplate
+10.00 USD
Get the most out of your new pickups by providing them with optimum electrical environment so they achieve their full sonic potential with our Goodbye-Soldering Harness (DIY Plug-n-Play install kit) where pickups & higher quality controls & wiring are installed fast and easy without any soldering.
To include a KHP-90 harness after this order is added to the CART click ADD ANOTHER PRODUCT and navigate to >Products > Harness >Gibson type ... and ADD TO CART as a separate item.
Please go to the TAB below and choose your Harness model.
129.00 USD
129.00 USD
129.00 USD
144.00 USD
93.00 USD
93.00 USD
119.00 USD
Choose For Soldering into your guitar if the pickups are to be connected to stock guitar electrics other than a Kinman Goodbye Soldering Harness that uses miniature plugs.
if in doubt choose the first option since it suits either shielding condition
3 conductor hook-up cable plus grounded magnets are necessary for Series switching and/or Phase reversing. (in a set of 3 in a Kinman K9 harness, it's for middle pickup only) +$5 upcharge.
Cables are long enough for Stock Strats. If you require longer cables state the lengths you require in the ADDITIONAL NOTES box on the Shipping page. Lengths stated below are from the middle of the pickup to the tip of the cable.
neck 250mm (9-3/4") long
middle 188mm (7-3/8") long
bridge 152mm (6") long
Choose For Soldering into your guitar if the pickups are to be connected to stock guitar electrics other than a Kinman Goodbye Soldering Harness that uses miniature plugs.
3 conductor hook-up cable is necessary for Series switching and/or Phase reversing.
This kit is positive latching and will not come apart without force. It has short leads and is intended to connect a normal pickup hook-up cable to the original pickup cable after the original pickup has been cut from it. Details are in >Technical >Install Guides.
Choose Plug into a Kinman Harness if the pickups are to be used with an existing Kinman Goodbye Soldering Harness
Note: Older versions of Kinman Harness use solder connections, please check
3 conductor hook-up cable plus grounded magnets are necessary for Series switching and/or Phase reversing. (in a set of 3 it's for middle pickup only) +$5 upcharge.
The ground is a separate wire from the Plug and is not shown.
Cables are long enough for Stock Strats. If you require longer cables state the lengths you require in the ADDITIONAL NOTES box on the Shipping page. Lengths stated below are from the middle of the pickup to the tip of the cable.
neck 250mm (9-3/4") long
middle 188mm (7-3/8") long
bridge 152mm (6") long
Please indicate what the Bridge pickup is: Humbucker* or P-90 it will have 500k Volume pot load Strat pickups will have 250k Ohm Volume pot load.
NOTE: * Humbuckers can not be split to single coil with this harness.
Choose the K9-H instead.
Please indicate what the Bridge pickup are: Humbucker* or P-90 it will have 500k Volume pot load Strat pickups will have 250k Ohm Volume pot load.
NOTE: * Humbuckers can not be split to single coil with this harness.
Choose the K9-H instead.
Strat pickups require 250k volume pot load.
Which positions are for Humbucker or P-90 that require 500k volume pot load.
Is the harness for a rear rout install where the controls are mounted through the wood? Click to see image.
To include a KHP-90 harness after this order is added to the CART click ADD ANOTHER PRODUCT and navigate to >Products > Harness >Gibson type ... and ADD TO CART as a separate item.
You will now be redirected to the Magnum Opus Order Channel. Click OK if you want to continue or CANCEL if you want to stay on this page.
Synergy is an interaction or cooperation giving rise to a whole that is greater than the simple sum of its parts. The term synergy comes from the Attic Greek word συνεργία synergia meaning working together.
An opus is a created work, usually musical in nature.
A common usage of opus is with the term magnum opus which refers to one's greatest work, musical or otherwise
https://www.vocabulary.com/dictionary/opus
this_content
